Venom Group International Medion Dual 10 amp Manuel D'utilisation page 12

USER SETUP PROGRAMMING MENU (CONTINUED)
This program sets the maximum charge capacity that will be supplied to the battery
during charge. If the delta peak voltage is not detected nor the safety timer expired
for some reason, this feature will automatically stop the process at the selected
capacity value.
The beep sounds every time a button is pressed to confirm your action. The beep or
melody sounds at various times during operation to alert different mode changes.
These audible sounds can be On or Off.
0668
An optional feature to protect the battery is the
external temperature probe. The temperature cut-
off can be On or Off. If it is On, set the maximum
temperature at which the charger should allow
battery to reach during charge. Once a battery
reaches this temperature during charge, the process
will be terminated to protect the battery.
When using the battery cycle feature of charging
and discharging, a battery will become warm after
the charge or discharge period. This program can
insert a time delay to occur after each charge and
discharge process to allow the battery adequate
time to cool down before being subjected to the next
process. The value ranges from 1-60 minutes.
Trickle charge mode for NiMH, NiCD, and PB
batteries. This can be set to On or Off. With this
mode turned On, the charger will automatically
supply a trickle current to the battery after fast
charging has ended. This trickle will be enough to
maintain full charge without overheating.
Note: Trickle charging a NiMH battery may damage the pack
When you start a charge process, the integral
safety timer automatically starts running at the same
time. This is to prevent overcharging the battery if
it proves faulty, or if the termination circuit cannot
detect that the battery is full. The value for the safety
timer should be generous enough to allow a full
charge of the battery.
[ 11 ]