Fast" Charging Lithium Batteries - Venom Group International Medion Dual 10 amp Manuel D'utilisation

LITHIUM BATTERY PROGRAM (CONTINUED)
The screen shows the real-time progress during charge process. To stop
charging press Batt Type/Stop button once.
and ends earlier. The charging current will go to 1/5 from the initial value to end
the process while the normal Lithium charge process reduces to 1/10 during the
CV term. The final charged capacity will be slightly less than if using the regular
charge feature, and charge time is greatly reduced.
STORAGE MODE FOR LITHIUM BATTERY
Lithium batteries, if they are to be stored for a long time, need to be conditioned
and have their voltage set to a prescribed level to maintain long life. If stored
fully charged for a long period of time, packs will increase in internal resistance,
and lose power, or capacity. Use the storage feature for batteries that will be
stored for more than 30 days.
This program will determine to charge or discharge the battery to the storage
voltage depending on the battery at its initial stage. They are different from the
type of Lithium battery. 3.75V for LiIo, 3.85V for LiPO, and 3.3V for LiFe per cell. If
the voltage of battery at the start is over the storage voltage, the program will
start to discharge.
dual 10 amp
FAST CHARGING LITHIUM BATTERY
Lithium charge profiles are set so the feeding
current gradually reduces near the end of the
charge to maintain the constant voltage. (CV)
To finish the charging process faster, this program
shortens the amount of time for the CV process
You can set up the charging current and the
voltage of the battery pack being charged. As you
press Start/Enter button, the voltage confirmation
will be displayed. Then if you confirm the voltage
and current, press Start/Enter button again to
start charging.
The screen shows the real-time progress during
fast charge process. To stop charging press Batt
Type/Stop button once.
[ 14 ]