Specification; Intent Of Use - Enerpac AVBOLT Manuel D'instructions

Specification

Intent of Use

The pump unit may only be used in accordance with the operating instructions for Avdel
®
Avdel fasteners.
The pump unit is an electrically driven, hydraulic power source. When coupled to a compatible Avdel
the relevant nose assembly is attached, it can then be used to install a range of Avbolt
Infalok ® , fasteners in industrial environments.
Refer to the table below for the list of applicable fasteners and associated nose equipment and placing tools.
FASTENER
TYPE
AVBOLT ®
AVDELOK ®
AVSEAL ® II
®
INFALOK
* Nose assembly with jaw release.
The tool is fitted with two Hydraulic Hoses and an electrical Control Cable, 0.6m in length. Additional hydraulic hose and
cable extension lengths are available to order separately as required. Refer to the table below for the available hose
assembly lengths and associated part numbers.
The safety instructions must be followed at all times.
6
NOSE ASSEMBLY
SIZE PART NUMBER
5/16" 73430-03300
3/8" 73430-03200
73432-03100
1/2"
73433-03100*
73412-03600
5/8" 73412-03400
3/8" 73430-03100
16 mm 73430-05000
73432-03200
1/2"
73433-03200*
73412-03100*
5/8" 73412-03200*
3/4" 73412-03300*
7/8" 73410-03200*
1" 73410-03100*
HYDRAULIC HOSE ASSEMBLY
PART NUMBER
07008-00448
07008-00449
07008-00450
®
placing tools and for placing of
® ®
, Avdelok
PLACING TOOL
TYPE PART NUMBER
AV™10 73430-02000
AV™10 73430-02000
AV™15 73432-02000
AV™15 73432-02000
AV™30 73434-02000
AV™30 73434-02000
AV™10 73430-02000
AV™10 73430-02000
AV™15 73432-02000
AV™15 73432-02000
AV™30 73434-02000
AV™30 73434-02000
AV™30 73434-02000
AV™50 73435-02000
AV™50 73435-02000
HOSE LENGTH
5 Metre
10 Metre
15 Metre
®
placing tool and
®
, Avseal II and