Safety Regulations; Layout And Items Supplied - EINHELL TC-TS 1200 Instructions D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.

2. Layout and items supplied

2.1 Layout (Fig. 1-3, 5, 6, 8, 10, 14)
1. Sawing table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
7 Parallel stop
8 Hand wheel
9 Locking grip
10 Base frame
11 On/Off switch
12 Locking knob
13 Rubber foot
14 Cross stop
15 Screw
16 Extractor adapter
17 Countersunk head screw
18 Hole (splitter)
19 Fastening screw
20 Screw
21 Groove
22 Scale
23 Stop rail
24 Holder
Anl_TC_TS_1200_SPK1.indb 22 Anl_TC_TS_1200_SPK1.indb 22
GB
25 Slot
26 Screw
27 Slot
28 Bottom saw blade cover
29 Tool hook
30 19/8 mm ring wrench
31 10/8 mm ring wrench
32 Cover plate
33 Screws for table insert
a Clamping plate
b Washer
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Sawblade guard
•
Push stick
•
Parallel stop
•
Cross stop
•
Assembly material
•
19/8 mm ring wrench
•
10/8 mm ring wrench
•
Original operating instructions
•
Safety information
- 22 -
03.11.2016 08:51:18 03.11.2016 08:51:18