Fault Diagnosis; Indicator Lights; Model Selection - Daikin FWG05AATNMV1 Manuel D'installation

FAULT DIAGNOSIS

Wireless Controller
When there is infrared remote control operating signal, the signal receiver on indoor unit will make a <beep> for signal
acceptance confirmation.
Wired Controller
If there is any abnormal condition detected, wired controller will blink the error code.
1. Room Sensor Open or Short
2. Pipe Water sensor Open or Short
3. Pipe Water Temperature poor
4. Pipe Water Temperature bad/fault
5. Water Pump Fault
6. Hardware Error (tact switch pin Short/M3 or M4
Mode with valveless section)
7. Window Open activated*
8. Antifreeze mode activated*
9. Load Shedding activated*
* Only applicable for 4-pipes system
A) MODEL SELECTION
LIVE
1 IM-CKEW(DC)-1013(1)DAIKIN-EN.i12 12 1 IM-CKEW(DC)-1013(1)DAIKIN-EN.i12 12

INDICATOR LIGHTS

Event
FAN COIL UNIT CONTROLLER BOARD SETTING
(APPLICABLE FOR 4 PIPES UNITS ONLY)
L
HTR
H_SEN C_SEN
Power LED Timer LED
Blink 1 time -
Blink 2 times -
Blink 3 times -
- Blink 1 time
- Blink 2 times
- Blink 6 times
Blink 6 times -
Blink 7 times -
Blink 8 times -
CN_TW
CN_PGRM
CN_STP
ROOM
CN_WIR
1-12
Error Code
Blink E1
Blink E2
Blink E4
Blink E5
Blink E6
Blink E8
-
-
-
CN_DRY
M1
M2
Model M3
M3
M4
Model M4
CN_DSP
7/1/14 2:39:07 PM 7/1/14 2:39:07 PM