Charging Up The Battery; Assembling The Device - Cleanmaxx BR-SDJ02G2 Mode D'emploi

Charging Up the Battery

PLEASE NOTE!
■ Only connect the charger to a plug socket that is properly installed and matches the
technical data of the charger. The plug socket must also be readily accessible after
connection so that the connection to the mains can quickly be isolated.
■ Pull the charger out of the plug socket if an error occurs during operation or before a
thunderstorm.
■ It is essential that you charge up the battery fully before you fi rst use the device in
order to achieve the maximum charging capacity. If the battery is fully discharged
during use, it must be fully charged up again before it is next used.
PLEASE NOTE: The battery needs approximately 8 hours to charge up on a fi rst charge.
The length of time required for subsequent recharging depends on the charging status of
the battery in each case; if the battery is fl at, it is approximately 5 hours.
4. Pull the charger out of the plug socket.
5. Remove the battery from the charger by pressing together the two release buttons on
the side of the battery and pulling out the battery at the same time.

Assembling the Device

17
1. Insert the battery (2) into the charger (3) until you
hear it engage. Make sure that the two arrows are
pointing towards each other.
2. Connect the charger to an easily accessible plug
socket.
3. Fully charge up the battery.
1. Plug the bottom shaft piece (9) onto the shaft piece of the
cleaning foot (5). Make sure that the two arrows on the
shaft pieces are pointing towards each other. When you
push them together, press together the two locking lugs on
the shaft piece of the cleaning foot. The locking lugs must
then engage in the openings of the bottom shaft piece.
2. Screw the middle shaft piece (12) onto the bottom shaft
piece and the top shaft piece (13) onto the middle shaft
piece.
3. Insert the battery (2) into the battery compartment (7) on
the bottom shaft piece. Make sure that the two arrows are
pointing towards each other.
EN