Use - Cleanmaxx BR-SDJ02G2 Mode D'emploi

EN

Use

PLEASE NOTE!
■ Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
■ When you lift up the device, always keep the cleaning foot horizontal so that no dirt
can fall out of the dirt container.
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
1. Move the On / Off switch (10) to the ON position to switch on the device. The brushes
of the cleaning foot (5) start to rotate.
2. Move the cleaning foot over the surface which is to be cleaned. The dirt is picked up
by the rotating brushes and collected in the dirt container (6) on the bottom of the
cleaning foot.
If too much dirt blocks up the brushes, they may come to a standstill. In this case,
move the On / Off switch to the OFF position, take the battery (2) out of the battery
compartment (7) and clean the brushes (see the "Cleaning and Storage" chapter).
3. Move the On / Off switch to the OFF position to switch off the device.
4. Empty the dirt container after each use (see the "Cleaning and Storage" chapter –
"Emptying the Dirt Container").
Bending the Shaft
The shaft can be bent up to an angle of 90° to make it easier to handle.
18
1. Slide up the button on the side of the joint (11) and at the
same time move the shaft towards the battery compart-
ment (7). The angle is infi nitely adjustable.
2. Let go of the button to fi x the shaft at the set angle.