Ovention Double MiLO Manuel D'installation Et D'utilisation page 17

English
5. Remove and clean the upper and lower crumb trays in
each of the oven chambers. To clean the crumb trays in
each oven chamber:
a. Open the oven door.
b. Remove the lower crumb tray:
• Lift up the front of the lower IR element pack, and hold
in the raised position.
Front of Lower
IR Element
Pack in raised
position.
Lower
Crumb Tray
Removing a Lower Crumb Tray
• Remove the crumb tray by pulling it down and out of
the lower IR element pack.
• Pull the crumb tray out of the oven chamber.
c. Remove the upper crumb tray:
• Release the two retaining latches that hold
the upper IR element pack in position.
• Lower the front of the upper IR element
pack.
NOTE: The upper and lower IR element packs are hinged on
the back side.
Upper
Crumb Tray
Front of Upper
IR Element
Pack in lowered
position.
Removing an Upper Crumb Tray
• Remove the crumb tray by lifting it up and out of the
upper IR element pack.
• Pull the crumb tray out of the oven chamber.
d. Spray Chemco Dirt Buster III Oven Cleaner onto both
sides of each crumb tray. Allow the cleaner to sit for 3–5
minutes.
e. Using a non–abrasive nylon scouring pad, apply
pressure to wipe away grease residue.
f. Wipe the crumb trays clean using a damp, non-abrasive
cloth and allow to air dry.
Form No. OVMILOM-0817
6. Reinstall the upper and lower crumb trays into each oven
chamber. To install the crumb trays in each oven chamber:
a. Open the oven door.
b. Install the upper crumb tray:
Retaining
Latch
Back edge
of crumb
c. Install the lower crumb tray:
Channel
7. Perform the "Weekly Cleaning" procedure in this section.
17
• Align the air channels on the crumb tray with the gaps
on the upper IR element pack.
• Push the back edge of the crumb tray into the slot
along the back side of the oven chamber, above the
IR element pack.
• Raise the upper IR element pack while guiding the
crumb tray into the element pack.
• Rotate the retaining latches into position on the
upper IR element pack to secure the element pack in
position.
Retaining Latch
tray.
Air Channel
Replacing an Upper Crumb Tray
• While holding up the lower IR element pack, align the
air channels on the crumb tray with the gaps on the IR
element pack.
• Push the back edge of the crumb tray into the slot
along the back side of the oven chamber, below the
IR element pack.
• Lower the upper IR element pack while guiding the
crumb tray into the element pack.
Air
Replacing a Lower Crumb Tray
MAINTENANCE
Gap
Gap