Dismantling And Repairs - Festo DSBC-40-30-PPVA-N3 Notice D'utilisation

Pneumatic linear cylinder
Place the proximity switches as follows:
S
With cylinders with groove
In the integrated groove for proximity
switches.
Fig. 12
Always use proximity switches at the distances specified.
S
If the gap is too large, the switch will not be actuated reliably.
7 Care and maintenance
If the piston rod is dirty, clean it with a soft cloth.
S
All non−abrasive cleaning agents are permitted.
Otherwise the cylinders do not require maintenance due to their service life
lubrication. Regular removal of the lubricating grease on the surface of the
piston rod will reduce the service life.
8

Dismantling and repairs

With non−roller−burnished cylinders:
Make use of the opportunity to have your cylinder overhauled by the Festo
S
repair service.
Order a suitable wearing−parts set if your cylinder shows the following signs of
S
wear:
loss of power during operation
increased air consumption
(noise emission).
An overview of wearing parts available can be found at the Internet address
(see last page of these instructions).
Roller−burnished cylinders cannot be overhauled.
Festo 0506a English
With cylinders without groove
Or with a fastening kit so that the
proximity switches lie properly on the
cylinder barrel.
19