Elem Garden Technic MT60-139CC Traduction Des Instructions D'origine page 15

Install the resistance pole :
Fix the resistance pole on the base with a
columniform pin, then insert a B-shape pin on the
columniform pin to prevent it moving out.
OPERATING INSTRUCTIONS
Pre-Start Inspection
Make sure all safety guards are in place and all
nuts and bolts are secure.
Check oil level in engine crankcase.
Important! Engine is shipped
from the factory without oil. You
must add engine oil before
Inspect air filter for cleanliness.
Check the fuel supply. Do not fill gas tank
completely full, allow space for fuel to expand.
Be sure spark plug wire is attached and spark
plug is tightened securely.
Check depth regulator lever position.
Examine underneath and around engine for signs
of oil or fuel leaks.
Inspect fuel hoses for tightness and fuel seepage.
Look for signs of engine damage.
Remove excessive debris from muffler area and
recoil starter
Start the Engine
Move the accelerator lever to "
Grasp starter handle and pull out slowly, until it pulls
slightly harder.
Pull rope with a rapid full arm stroke until engine
runs.
starting engine.
" position.
After engine starts running, move accelerator lever
to the appropriate position.
Stop the Engine
Move accelerator lever to "OFF" position.
Normal operation
The clutch engages and disengages the power from
the engine to the transmission.
When the clutch lever is squeezed, the clutch is
engaged and power is transmitted. Squeeze the
lever, the tool will be rotated.
When the lever is released, the clutch is disengaged
and power is not transmitted.
Release the clutch lever, the tool will be stopped.
Adjustment
Wheel adjustment
Put the wheel in position 1 for tillering.
ATTENTION!
Transport the unit with the wheel in position 2.
The wheel should be set only when the
engine is switched off!
Depth adjustment
Change the depth gauge for the
high tillering required. There are 3 different
possible positions.
Handlebar adjustment
Disentangle the fastening bolts on both sides, adjust
the handlebar to a suitable position, then tighten the
bolts.
15