Multiplex ROXXY BL-Control OPTO 900 Série Notice D'utilisation page 17

10. Reverse function (Boat and Car modes only)
In Boat or Car mode the Reverse function is used for selecting whether
the motor works only in one direction of rotation, or in forward and
reverse. In "One Way" mode (only one direction of rotation) the motor's
direction of rotation can also be selected: the two options are forward
and reverse.
In "Two Way" mode the speed controller is set up for forward / reverse
operation. Caution: changing the direction or motor rotation may cause
the cancellation of other settings.
11. Governor Response - Helicopter mode only
This mode is used for setting the characteristics of the speed controller
in speed governor (regulator) mode. The available options are Slowest /
Slow / Normal / Fast / Fastest.
Caution: the faster the value you select, the higher the current drawn
from the battery. We recommend that you select a fairly low setting in
order to avoid premature damage to the speed controller and / or the
l ight battery.
12. Governor On / Off - Helicopter mode only
This mode is used for switching speed governor (regulator) operation
on and off. Governor mode stabilises the pre-set rotational speed and
keeps it virtually constant. The options are: "On" mode for stabilised, or
"Off" mode for non-stabilised.
13. Motor Pole Number
In Motor Pole Number mode you can enter the number of poles in your
motor. This value is important for indicating the exact rotational speed.
The available range extends from 2 to 36 poles.
www.modellmarkt24.ch www.modellmarkt24.ch
14. Gear Ratio
This mode allows you to enter the individual gearbox ratio you are
using. The value for rotational speed indication is calculated using the
number of motor poles and the gearbox reduction ratio. The available
range of values is from 1.0 : 1 to 25.0 : 1.
15. Max. RPM & Average RPM
This mode shows you the maximum and average rotational speeds
recorded during the last l ight, taking into account the values set
under Points 6.14 and 6.15.
16. Down Load (Daten schreiben)
Download mode is used for writing (transferring) set values to the
speed controller. Press the INC button to start the process, and the
Programmer then beeps once every second until the procedure is com-
plete. If you wish to interrupt the process, simply press the DEC button.
17. Restore Memory
Restore Memory is used to access values which have been stored in
the Programmer's own memory. Press the INC button to start the pro-
cess, and the Programmer then beeps once every second until the
procedure is complete. If you wish to interrupt the process, simply press
the DEC button.
18. Backup Memory
Backup Memory mode allows you to store permanently the selected
values in the Programmer's integral memory. Press the INC button to
start the process, and the Programmer then beeps once every second
until the procedure is complete. The values set on the speed controller
itself are not affected by this action. If you wish to interrupt the process,
simply press the DEC button.
17