Programming In Detail - Multiplex Roxxy Bl-Control Opto 900 Série Notice D'utilisation

7. Programming in detail

1. Battery Type
Use the DEC or INC button to set the desired battery type. When you
have selected the new battery type you may i nd that the previously set
"CUT OFF VOLTAGE" and "CUT OFF TYPE" parameters have changed.
The DEC and INC buttons are always used to set the modes.
2. Cut Off Voltage
The Cut Off voltage is determined by the selected battery type. With
LiPo in Auto Mode, then the controller cuts off at 3 V per cell; a NiCd will
be 5.5 V total voltage. Adjust these values using DEC and INC buttons.
The scale is from 4.5-50 Volt.
3. Cut Off Type
In Cut Off Type mode you can select the cut-off method when battery
voltage falls to the set threshold. The options are "Soft Off" or "Hard
Off". Use the DEC and INC buttons to set the modes.
4. Motor Direction
In Motor Direction mode you can select the direction of rotation of your
motor: the two options are normal and reversed.
5. Advance Timing
Advance Timing is an alternative term for motor timing. This mode
alters the advance of the rotational i eld, which has a similar effect to
"advancing the ignition point". In general terms a setting of 8° is suitable
for most motors. If you wish to use a special set-up for your motor, we
recommend the following ranges of values: 0° to 10° for in-runner
motors, and 15° to 25° for out-runner motors.
16
www.modellmarkt24.ch www.modellmarkt24.ch
6. Acceleration
In Acceleration mode you can set how fast the controller runs up to
maximum speed. This is important if the throttle function is assigned to
a switch, as it determines the delay, i.e. the speed with which the motor
ramps up to "full-throttle".
Example: Lowest acceleration or Highest acceleration.
Variable parameters:
Lowest / Low / Normal / High / Highest, set using the DEC and INC
buttons.
7. Start Power
In the Start Power menu you can set the level of power (torque) which
the motor produces initially, i.e. from a stand-still. If you are using the
controller in a model helicopter, the value should be small in order to
avoid premature gear wear. The available values are Lowest / Low /
Normal / High / Highest.
8. Air Brake Type
When in Air mode (model aircraft), the controller's motor brake effect
can be adjusted, enabling the user to decide whether the motor co-
mes to a halt gradually or suddenly. You can select the modes Slow /
Normal / Fast, or a percentage setting (5 - 100% - 100% equates to a
sudden stop) using the DEC and INC buttons.
9. Air Brake On/Off - Air mode only
This menu point is used for switching the motor brake on or off.