Safety Rules - Aerotec Airliner 2 compact Manuel Utilisateur

GB Preserve this handbook for future reference
Before using the compressor, read the ins-
tructions for use carefully and comply with
the following safety precautions. consult
this handbook if you have any doubts re-
garding functioning.
Preserve all the documentation so that an-
yone who uses the compressor can consult
this beforehand.

1. SAFEtY ruLES

this symbol indicates warnings to be read
before using the product so as to prevent
injury to the user.
compressed air is a potentially dangerous
form of energy; always take great care
when using the compressor and its
accessories.
Warning: the compressor may restart
when power is restored following a black-
out.
An AcouStic PrESSurE's value of 4m.
corresponds to the AcouStic PoWEr's
value stated on the yellow label located on
the compressor, minus 20 dB.
Do'S
- The compressor must be used in a suitable
environment (well ventilated with an ambient
temperature of between +5°C and +40°C) and
never in places with dust, acids, vapors, explo-
sive or flammable gases.
- Keep the work area free. When operating, the
compressor must be placed on a stable sur-
face.
- Safety goggles should be worn when using
the compressor in order to protect the eyes
against any foreign bodies lifted by the jet of
air.
- If possible, when using air-powered accesso-
ries, wear safety clothing.
- Always maintain a safety distance of at least 2
meters between the compressor and the work
area.
- Check for correspondence between the com-
pressor plate data with the actual specifica-
tions of the electrical system. A variation of ±
10% with respect of the rated value is allowed.
- Insert the plug of the electrical cable in a so-
cket of suitable shape, voltage and frequency
complying with current regulations.
- Use extension cables with a maximum length
of 5 meters and with a cable cross-section of
not less than 1.5 mm . Use of extension cables
2
of different length and cross-section and also
of adapters and multiple sockets should be
avoided.
- Always use the handle to move the compres-
sor.
- When using compressed air, you must know
and comply with the safety precautions to be
adopted for each type of application (inflation,
air-powered tools, painting, washing with wa-
ter-based detergents only, clinching, etc.).
- To avoid overheating of the electric motor, this
compressor is designed for intermittent duty
operation as indicated on the technical data-
plate (for example, S3-25 means 1.5 minutes
ON, 8.5 minutes OFF). In case of overheating,
the thermal cutout of the motor is released,
automatically cutting off the power when the
temperature is too high due to excess current
take-off. The motor restarts automatically when
normal temperature conditions are restored.
Don'tS
- Never direct the jet of air towards persons,
animals or your body.
- Never let the compressor come into contact
with water or other liquids and never direct the
jet of liquids sprayed by tools connected to the
compressor towards the compressor: as the
appliance is live, this could cause electrocution
or short-circuits.
- Never use the appliance with bare feet or wet
hands or feet.
- Never yank the power cable to disconnect
the plug from the power outlet or to move the
compressor.
- Never leave the appliance exposed to adver-
se weather conditions (rain, sun, fog, snow).
- If this compressor is used outdoors, always
remember to stow it after use in a covered or
closed place.
- Never use the compressor outdoors in rain or
bad weather.nicht zudecken.
- Never allow inexpert persons to use the com-
pressor without suitable surveillance. Keep
animals at a distance from the work area.
- The compressed air produced by the com-
pressor cannot not be used for pharmaceuti-
cal, food or medical purposes or to fill the air
bottles of scuba divers.