Carbest CARA-MOVE II Manuel D'utilisation page 51

Handset Pairing
AWD Pairing
To configure your system for AWD mode, the handset (5) must be paired with only the front axle
electronic control unit (4). To do this, first ensure that as per section 'Installation - Electrical/Electronic
Components (AWD Configuration)' the data cable (33) is correctly connected to the two control units.
Turn on isolation switch (29) to provide power to both control units, a red and blue LED will illuminate
on each box. Remove the top cover (Fig.12.A) of the rear axle electronics box and press the small
button (Fig.18.A) as indicated in Fig.18 below. The blue LED on the rear axle box will turn OFF to
indicate that the wireless signal has been cut. Double press multi-function button (Fig.10.C) to turn on
handset. Allow at least 10 seconds for the handset to pair with the front axle control unit. If your
handset does not pair, go to settings and initiate the handset pairing option (see 'Operation - Handset
Functions). Ensure that whilst your handset is pairing, the electronic control units remain powered and
the blue LED on the rear axle control box remains OFF.
The signal strength indicator (Fig.17.A) will indicate when you have paired the system. The blue LED
on the front axle box will also flash to indicate that it is the unit that is paired. Once paired, ensure the
correct 'AWD mode' is selected in the handset settings (see 'Operation - Handset Functions). Turn off
the handset, and cut power to the control units by turning off the isolation switch (29). When you turn
the handset and isolation switch back on, the AWD pairing will be complete.
Fig.18
A
Note: For the handset (5) to be paired correctly for AWD, it must have not previously established a
connection with either electronic control unit (4). If this is the case, either use a second, unpaired
handset, or unpair the handset (5) from the respective control unit (4). To do this, turn on the isolation
key (29) and the handset (5). Go to settings and initiate the handset pairing function, as this starts,
double press the multi-function button (Fig.10.C) to stop the pairing process. Screen icon Fig.17.F
should show. Turn off the isolation key (29) to cut the power to the control unit and turn off the handset
(5). Now continue the standard process as stated above (AWD Pairing).
49