Siemens Z 4.0 Notice D'utilisation page 16

Masquer les pouces Voir aussi pour Z 4.0:
Table des Matières

Publicité

en
en
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt or rinsing it out.
21
Figure
Open the dust bag compartment lid
(see Figure 19).
Pull out the motor protection filter in the direction of the
arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter should be
rinsed out.
The filter must then be left to dry for at least 24 hours.
After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.
Replacing the micro-hygiene filter
This should be replaced with every replacement filter pack
22
Figure
Open the dust bag compartment lid
(see Figure 19).
Release the filter holder by moving the locking lever in
the direction of the arrow.
Remove the micro-hygiene filter. Insert the new micro-
hygiene filter into the vacuum cleaner.
Insert the filter holder into the vacuum cleaner and clip
into place.
Replacing the micro active carbon filter
If your vacuum cleaner is equipped with a micro active
carbon filter, this should be replaced every six months.
23
Figure
Open the dust bag compartment lid
(see Figure 19).
Release the filter holder by moving the locking lever in
the direction of the arrow.
Remove the micro active carbon filter.
Insert the new micro active carbon filter.
Insert the filter holder into the vacuum cleaner and clip
into place.
Replacing the HEPA filter
If your vacuum cleaner is equipped with a HEPA filter, this
should be replaced once a year.
24
Figure
Open the dust bag compartment lid (see Figure 19).
Release the Hepa filter by moving the locking lever in the
direction of the arrow and remove it from the vacuum
cleaner.
Insert the new HEPA filter and clip into place.
If you have used the vacuum cleaner for vacuuming fine
dust particles, clean the motor protection filter and, if
necessary, replace micro hygiene filter, the micro active
carbon filter or Hepa filter.
10
Care
Always switch off the vacuum cleaner and disconnect the
power cord from the mains before cleaning the appliance.
The vacuum cleaner and plastic accessories can be
cleaned with a commercial plastic cleaner.
Do not use a scourer, glass-cleaning agent or all-
!
purpose cleaning product. Never immerse the
vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with a
second vacuum cleaner or simply wiped with a dry cloth or
dusting brush.
Subject to technical modifications.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Vsz42001

Table des Matières