Setting Alarm - THOMSON RT300 Manuel D'utilisation

Setting Alarm

The system must be in standby mode in order to set the alarm.
1. Activate alarm setting mode: Press and hold "PRE. - / ALARM 1" button for 3 seconds.
The hour indicator starts blinking on the display.
2. Press "SKIP+" or "SKIP-" to set the hour. Press "PRE. - / ALARM 1" button to confirm. The minute
indicator starts blinking.
3. Press "SKIP+" or "SKIP-" to set the minutes. Press "PRE. - / ALARM 1" button to confirm. The
alarm mode starts blinking.
4. Press "SKIP+" or "SKIP-" to choose one of the mode: BUZZ / RADIO. Press "PRE. - / ALARM 1"
button to confirm.
To set the second alarm time, repeat each of the above steps with the "PRE. + / ALARM 2" button.
Once you completed the alarm setting an alarm symbol will appear on the display.
Snooze function
Press "SNOOZE" button to suspend alarm sound for a few minutes. The alarm will start again after
approx. 9 minutes.
Deactivate the alarm
Press "PRE. - / ALARM 1" or "PRE. + / ALARM 2" button to turn off the alarm 1 or alarm 2.
Operation
Volume control
The volume can be easily controlled by tuning the "VOLUME CONTROL KNOB".
Sleep function
Press the "SLEEP" button shortly to adjust the sleep timer in 10 minutes steps from 120 minutes to 10
and 5 to OFF.
ANTENNA
For optimal reception, extend the antenna, move to fully extend and adjust.
Listening to the AM / FM / LW Radio
1. Press the "STANDBY / BAND" button shortly to switch on the unit.
2. You can press the "STANDBY / BAND" button to change the AM / FM / LW radio frequency.
3. There are two options to search for and preset radio stations.
• Automatic scan:
Important! Any preset radio stations will be overridden.
Press and hold the "AMS / MODE" button for approx.3 seconds. The system scans the entire frequency
band for radio stations. Any stations found will be preset from lowest to highest frequency.
• Manual scan for audio stations:
Briefly press the "SKIP+" & "SKIP-" buttons, until you have found the radio station which you are
looking for. If you keep one of the buttons pressed down, the device will search to the previous,
respectively next radio station.
• Preset station:
1. Press and hold the "AMS / MODE" button on unit for about 2-3 seconds to start the automatic
preset process.
2. Display will show the memory sequence number and radio stations will be automatically preset
into the sequence number (Note: Each sequence number means 1 preset station while during
automatic preset process.)
3. Once all the stations were automatic preset, press the "PRE. - / ALARM 1" or "PRE. + / ALARM 2"
button to choose preset statoins.
- EN 6 -