Start-Up Of The Device/Introduction; Setting The Clock - THOMSON RT300 Manuel D'utilisation

Start-up of the device/introduction

• Select a suitable location for the device, such as a dry, flat, non-slip surface on which it is easy to
operate the machine.
• Ensure that the device is sufficiently ventilated.
• Remove the protective film from the display if it is still present.
Power Supply
• Ensure that the voltage is the same as that indicated on the model identification plate.
• Connect the power cable supplied (see battery compartment if necessary) to a properly installed
safety power socket and the mains connector AC on the back of the machine.
Inserting the Batteries (not supplied)
1. Open the lid of the battery compartment.
2. Insert 4 batteries of type UM-2 ("C" size) 1.5 V. Please ensure that the polarity is correct (see the
floor of the battery compartment)!
3. Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are automatically switched off.
CAUTION:
• Batteries can leak and lose battery acid. When not using the system for a long period of time,
remove the batteries.
• Different battery types or new and used batteries must not be used together.
• Do not dispose of batteries with household waste. Return old batteries to the respective collection
facilities or your dealer.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Danger of
explosion!
Turning device on/ off
• Press the "STANDBY / BAND" button to turn the device on.
• To turn off the product, press and hold the "STANDBY / BAND" button for approx. 3 seconds.

Setting the clock

The system must be in standby mode in order to set the clock.
1. Activate clock setting mode: Press and hold "CLOCK" button for 3 seconds. 24H starts blinking
on the display.
2. Press "SKIP+" or "SKIP-" to choose between 12-hour/24-hour format. Press "CLOCK" button to
confirm. The hour indicator starts blinking.
3. Press "SKIP+" or "SKIP-" to set the hour. Press "CLOCK" button to confirm. The minute indicator
starts blinking.
4. Press the "CLOCK" button to confirm the minute.
Note: If the product is disconnected from power, the clock setting needs to be reset.
- EN 5 -