EINHELL BT-PG 2000 Mode D'emploi D'origine page 14

Anleitung_BT_PG_2000_SPK1__ 19.07.12 14:26 Seite 14
GB
9. Troubleshooting
Fault
Engine does not start
Generator has too little or no
voltage
14
Cause
Automatic oil cut-out has not
responded
Spark plug fouled
No fuel
Controller or capacitor defective
Overcurrent circuit-breaker has
triggered
Air filter dirty
Remedy
Check oil level, top up engine oil
Clean or replace spark plug
(electrode spacing 0.6 mm)
Refuel / have the petrol cock
checked
Contact your dealer
Actuate the circuit-breaker and
reduce the consumers
Clean or replace the filter