LENCO BAR-013 Mode D'emploi page 10

device with USB power for charge if you still want to use the device.
2. If not, the Bluetooth Speaker will power off automatically when the
battery is keeping low energy level in some minutes.
3. In this case, the device cannot be turned on, until you recharging the
battery at least 10 ~ 15 minutes, because the rechargeable battery
has not enough energy.
N. Reset
In some circumstances, the device may encounter dead halt during use.
This device has design with built-in a mini tact switch which located at
the behind of the earphone jack, so it can provide reset function to
restart the device by pass through the earphone jack hole.
To Reset:
 Use a 1mm stick or similar object (like tooth stick), and carefully insert
the stick, use dull side, into the earphone jack hole until you feel to hit
the end. Actually that is the tact switch button surface.
 Then add a bit of force and you will get a click sound and feeling
return from switch. The device is reset and restart in seconds.
Important: Do not reset the device if it is proper working.
O. Trouble Shooting
No power
No sound
No radio station
No response from speaker  Restart the speaker by power off and on.
 Check battery is it charged with enough
energy.
 Check whether the device is in power off
mode.
 Check whether volume level is in lower
position on your speaker and mobile
phone or PC/Mac.
 Make sure that your Bluetooth device is
within the effective operation range.
 Check whether the Bluetooth device is
paired.
 Check whether the Bluetooth device show
connected.
 Check if you have selected the correct
audio source.
 Check whether the FM station is tuned in
correct frequency and programmed.
10