Firmware Updates - eQ-3 eqiva Key-BLE Mode D'emploi

from outside, if a lock cylinder with emergency and
hazard function is used. The door lock drive must
be in idle status (motor not moving) in this case.
Do not tighten the screws that fasten the lock
actuator to the base too tight, since it might jam
the drive and make opening from outside difficult.
7

Firmware updates

You can update the device firmware of the lock actuator in
case a new version is available. You are informed immedi-
ately via your smartphone as soon as a new firmware up-
date will be published.
Keep your smartphone within range of the device
while the firmware update is in progress.
To activate the update mode on the lock actuator, proceed
as follows:
• Press and hold down the button "Unlock" (C) for
4 seconds until the device LED (D) starts to flash
quickly.

Firmware updates

43