Batteries - eQ-3 eqiva Key-BLE Mode D'emploi

If necessary, please replace your lock cylinder by a
new one if it does not fulfil the installation
requirements.
4.2

Batteries

To insert or replace batteries, please proceed as follows:
• Remove the battery compartment cover (F) on the
right side of the device (see fig. 5) by pulling the cover
off using the notches at the bottom of the device.
• Take the used batteries out if necessary.
• If you use the device for the first time please remove
the insulation strip from the battery compartment or
insert three (new) 1.5 V LR6/mignon/AA batteries the
right way round. The device LED (D) shortly flashes
orange and the green. In addition, the device emits a
short audio signal.
• Reattach the battery compartment cover and latch it
into place.
Remove or change used batteries immediately to
prevent the batteries from leaking.
If the battery voltage is getting low it is displayed
via the app. Furthermore, the device emits an
audio signal and the device LED (D) flashed orange
after every basic function actuated. Change the
batteries in this case. The settings will not be lost.
Start-up
37