Lock Cylinder Requirements - eQ-3 eqiva Key-BLE Mode D'emploi

Start-up
and easy with the key as described previously.
In order to use the door opening function via smartphone,
the door seals must be intact and designed so that the door
will open on its own after completely unlatching the lock
because of the expansion of the door seal.
4.1.2

Lock cylinder requirements

The lock actuator is mounted directly on the cylinder lock
(J); when the appropriate key is inserted, the actuator caus-
es the cylinder to move. Accordingly, the cylinder lock (J)
must be dimensioned so that it juts out on the inside of the
door by 8 -15 mm more than the handle fitting (see fig. 4).
Determine the dimensions of the required lock cylinder (J)
using fig. 3. When selecting the lock cylinder, the inside di-
mension (L) and the outside dimension (M) of the cylinder
are important. In each case, measure from the fastening
screw (K) of the cylinder (J) in the lock fitting (including the
door fittings) and add 8 - 15 mm (ideally 10 mm) to the
inside dimension to calculate the suitable standard dimen-
sions (N) (see fig. 4).
Example:
You measure an outside dimension of 40 mm and an inside
dimension of 40 mm. Therefore, the cylinder is a 40/40 cyl-
inder. In order to use the lock actuator, you therefore need
the next standard size, a 40/50 cylinder. The cylinder will
then protrude inside by 10 mm.
36