Babyauto TownFix123 Notice D'instruction page 23

4. INSTALLING CHILD SEAT. GROUP 1.
WARNING
Make sure you have installed the ISOCLICK anchors before installing
the chair as indicated in Group 1.
1. Fit this child seat into the vehicle´s seat, making sure it is firmly
pressed against the vehicle seat backrest (4.1).
2. Raise the rear of the elevator upholstering ensuring you have
extracted the safety buckle
3. Pass the lap portion of the vehicle safety seat belt over the
elevator making sure that the tape is positioned as shown in fig.
4.4. passing it in front of the safety buckle E.
4. Return the elevator trim to its original position by affixing the Velcro
to ensure that it does not lift up and once more passing the safety
buckle E through this. The belt should be below the upholstery
(4.5).
5. Connect the belt to the buckle, making sure you hear a "Click"
and tighten the belt diagonally to ensure maximum tension of the
abdominal portion (4.6).
6. Thread the belt through the top of the back as shown in fig. 4.7. Be
sure to pass the tape through the belt guides on both sides, and
stretch the chest portion of the belt to reduce slack in the tape.
Group 1/2/3
Only suitable for Group 1, approx.
9 months to 4 years of age (9-18 Kg.)
E from its sheath (4.2 & 4.3).
www.babyauto.com www.babyauto.com
EN
23 23