SEVERIN WK 3475 Mode D'emploi page 12

Thermal safety cut-out
The pre-set thermal safety cut-out protects
the heating element from overheating should
the appliance be erroneously switched on
without any water, or if the heating plate
is calcifi ed. Once the safety cut-out has
switched off the kettle, it must be allowed to
cool down suffi ciently, or must be descaled
before it is switched on again.
Before using for the fi rst time
To clean the kettle, boil and discard the fi rst
fi lling of water.
Boiling water
∙ Remove the water container from its
base.
∙ Press the lid opener to open the lid.
∙ Fill the container with water to the desired
level, observing the Min (0.5 l) and Max
(1.7 l) markings.
∙ Close the lid and place the container
back on its base.
∙ Insert the plug into a suitable wall socket
and press the On/Off switch; the indicator
light comes on.
∙ The boiling process begins. After
reaching the boiling point, the appliance
is automatically switched off by the
integral steam cut-off device; the
indicator light goes out.
∙ To interrupt the boiling process, set the
On/Off switch to its Off position.
∙ To pour hot water, remove the container
from its base.
∙ To prevent hot steam from being emitted,
ensure that the lid remains closed while
pouring out the water.
12
∙ Remove the plug from the wall outlet
after use.
∙ Do not leave any residual water in the
container.
Power cord wind-up storage
The wind-up power cord storage under the
base facilitates limiting the length of the
power cord during use and makes it easy to
store the appliance.
Descaling
∙ Depending on the water quality in your
area, lime deposits may build up on the
heating element. It is advisable to remove
any such deposits at regular intervals.
∙ Any warranty claim will be null and
void if the appliance malfunctions
because of insuffi cient descaling.
∙ A mixture of 0.5 litres of water and 40 ml
of vinegar essence is suitable.
∙ Pour the descaler in.
∙ Switch the appliance on and let the
solution reach boiling point.
∙ Leave it to take effect for a short period.
∙ To clean the container after descaling,
rinse thoroughly with clean water.
∙ During descaling, ensure suffi cient
ventilation and do not inhale any vinegar
vapours.
∙ Do not pour descalers down enamel-
coated sinks.