EINHELL RUBIN Instructions De Montage page 5

Page 21
Important note: Make sure that the wider side of the
spacers is attached to the floor profile. The narrow
side is used to fix the plastic web panel.
Page 22
26
Assembly of the plastic web panels
on the sides
Important note: The outside of the plastic web
panels (with UV coating) is marked „Außenseite /
Outside" at the edge, and it is also the side onto
which the protective film has been stuck. Only
remove the protective film from the plastic web panel
you are currently installing.
26/a: Compensation profiles (item 6) are attached to
the upperside of the web panels and U-profiles
(item 5) to the underside. Please note the following
detail drawings 26/b and 26/c in this connection.
Page 23
26/b: Make sure that the compensation profiles are
attached to the web panels so that the raised part of
the compensation profile is on the inside of the web
panel.
Page 24
Top illustration: Assembly preview / reference
diagram (side) (illustration shows a 5-panel greenhouse)
Page 25
Figure 26/f: Profile diagram (double clip / side strut)
Tip: Use a solid object (e.g. the handle of a
screwdriver) to lightly tap several times on the clips
and knock them from the top down into position.
Page 26
Figure 26/g: Profile diagram (single clip / corner
profile)
Important note: Make sure that the wider side of the
spacers is attached to the floor profile. The narrow
side is used to fix the plastic web panel.
Page 27
27
Assembly of the plastic web panels on the
window rabbet profile
Important note: The outside of the plastic web
panels (with UV coating) is marked „Außenseite /
Outside" at the edge, and it is also the side onto
which the protective film has been stuck.
Only remove the protective film from the plastic web
panel you are currently installing.
ABA_RUBIN_Teil2_Titel+GB.pmd 5
Page 28
27/d: Loosen the screws on the window rabbet profile
and slide the window rabbet profile far enough down
until the plastic web panel is fully enclosed (refer to
the profile diagram 27/d). Then retighten the nuts.
Page 29
28
Assembly of the plastic web panels
on the roof
Important note: The outside of the plastic web
panels (with UV coating) is marked „Außenseite /
Outside" at the edge, and it is also the side onto
which the protective film has been stuck. Only
remove the protective film from the plastic web panel
you are currently installing.
28/a: Compensation profiles (item 4) are attached to
the upperside of the web panels and U-profiles (item 3)
to the underside. Please note the following detail
drawings 28/b and 28/c in this connection.
Page 30
28/b: Make sure that the compensation profiles are
attached to the web panels so that the raised part of
the compensation profile is on the inside of the web
panel.
Page 31
Top illustration: Assembly preview / reference
diagram (roof) (illustration shows a 5-panel
greenhouse)
Page 32
Please note (Figure 28/e): Always use a safety
stepladder when installing the clips on the roof, and
also take great care to ensure that the stepladder has
a secure footing.
Tip: Use a solid object (e.g. the handle of a
screwdriver) to lightly tap several times on the clips
and knock them from the top down into position.
Figure 28/f: Profile diagram (double clip / side strut)
Figure 28/g: Profile diagram (single clip / corner
profile)
Page 33
29
Assembly of the rubber profile on the
window rabbet profile
29/a + 29/b: Cut a length of approximately 73 cm of
window sealing profile and pull it into the guide rail of
the window rabbet profile (refer to the profile dia-
gram). Make sure that the rubber protrudes slightly
above the two clips on the roof struts.
07.04.2006, 09:48
5