TESTO 104 Mode D'emploi page 13

8. Configuring the instrument
Changing the measurement mode
 Instrument is switched off.
1 Open the configuration mode: open the immersion/penetration
probe while holding down
Depending on the preconfigured settings, either Hold or
Auto Hold is shown.
2 Select Hold or Auto Hold: press
- Configuration is complete. The instrument changes to the
measurement mode.
Displaying min/max values
Only Hold and Auto Hold values are stored in the min/max
memory.
 Instrument is switched on.
1 Immerse / penetrate the probe into the object being measured.
2 In the Hold measurement mode: press
In the Auto Hold measurement mode: wait until a signal is
emitted and Auto Hold lights up.
Hold
3 Hold down
Max Min
- Max lights up and the maximum measurement value is shown.
Hold
4 Press .
Max Min
- Min lights up and the minimum measurement value is shown.
Hold
5 Press .
Max Min
- The instrument changes to the measurement mode.
Deleting min/max values
  S teps 1-4 of "Displaying min/max values" have been followed.
Hold
5 Hold down
Max Min
- Max Min CLr. appears on the display.
- The instrument changes to the measurement mode.
Hold
.
Max Min
for at least 2 seconds.
for at least 2 seconds.
8. Configuring the instrument
Hold
.
Max Min
Hold
.
Max Min
13 13