Use - DS Produkte MAXXMEE KB-6005 Mode D'emploi

Laundry Care Centre
Duration: approx. 15-20 min. The operat-
ing lamp (13) pulsates green.
A beep is heard and then warm air is
released into the fabric cover until the
clothing is dry.
The operating lamp pulsates red.
Duration: 20 – 120 minutes depending
how wet the clothing is.
A beep is heard and fi nally cold air is
released into the fabric cover. The operat-
ing lamp pulsates blue.
Duration: 2 minutes
A beep is heard and the operating lamp
fl ashes red while the area inside the fabric
cover is still warm. As soon as the area
inside has cooled down suffi ciently, 3
beeps are heard and the device switches
to stand-by.
Freshening Up Mode
Cold air is sucked in from the outside and
released into the fabric cover.
The operating lamp (13) pulsates blue.
Duration: approx. 10 minutes
 
Each mode can be manually inter-
rupted, changed or stopped with
the button
Three beeps are heard and the device
switches to stand-by.

USE

Please Note!
■
Do not leave the device unattended
during operation.
■
Be aware that the weights may like-
wise become hot during use. Allow
them to cool down appropriately
before they are detached from the
item of clothing.
■
Allow the device to cool down after
each smoothing process.
01857_DE-EN-FR-NL_inlay_A5_V1.2.indb 17 01857_DE-EN-FR-NL_inlay_A5_V1.2.indb 17
►II
(14).
 
For the best results, the device
should ideally be used in a room
that is as cool as possible. We
recommend a maximum room
temperature of 25°C.
1. Fully assemble or take apart the de-
vice (see the "Assembly" chapter).
2. If smoothing mode is to be used, fi ll
the water tank (17) (see the "Filling
the Water Tank" chapter).
3. Flip down the hanger holder (16)
(Illustration G).
4. Prepare the item(s) of clothing you want
(see the "Preparing Clothing" chapter)
and hang them in the hanger holder.
5. Close up the fabric cover with the zip.
6. Plug the mains plug into an easily
accessible plug socket.
7. Move the main switch (5) on the back
of the main device (4) to position I. A
beep is heard and the operating lamp
(13) fl ashes alternately red-green-blue.
The device is in stand-by mode.
8. Select the mode you want by turning the
dial (15) (see the "Functions" chapter).
►II
9. Press the button
device. A beep is heard and the oper-
ating lamp pulsates in the correspond-
ing colour.
The device now runs through the
mode which is set (see the "Func-
tions" chapter). When the mode has
ended, 3 beeps are heard and the de-
vice automatically switches to stand-
by mode. The operating lamp again
lights up alternately red-green-blue.
 
When the water tank is empty,
5 beeps are heard before the
device switches to stand-by.
10. Move the main switch to the posi-
tion 0 and pull the mains plug out of
the plug socket.
11. Allow the device to cool down com-
pletely.
EN
(14) to start the
17
13.05.2020 12:16:43 13.05.2020 12:16:43