Update Firmware / Speaker Presets; Reset Pin To Factory Settings - LD Systems CURV 500 iAMP Manuel D'utilisation

UPDATE FIRMWARE / SPEAKER PRESETS

Current firmware and loudspeaker presets can be found together in an update file in the download area of the product at
WWW.LD-SYSTEMS.COM.
Make sure you follow the instructions exactly during the update process! Otherwise, the amplifier's device software may
be damaged and the amplifier made unusable. If this occurs, the device must be taken to an authorised service centre and
carefully restored (not covered under warranty!).
Download the latest file, save it to your computer and unzip it. Switch on the CURV 500 IAMP, connect it to your computer and start the
software as described in INSTALLATION AND CONNECTION. Now click on "Firmware" and then on the button "Browse for update file". Select
the previously saved update file in the appropriate folder and click on "Start programming". The progress of the update process will now
be displayed as a percentage and once the process is complete, the CURV 500 IAMP will restart automatically. Wait until the main display is
shown on the amplifier display, then switch it off, wait 2 minutes, and then switch the amplifier on again. When the main display reappears,
the update process is completed and the amplifier is ready for operation.

RESET PIN TO FACTORY SETTINGS

If the PIN for unlocking the amplifier becomes lost, the software can be used to reset it to the factory setting 1234. Connect the CURV 500
IAMP with your computer and start the software as described in INSTALLATION AND CONNECTION. Now click on "Set default PIN: (1234)".
As confirmation of the process, a window with the information "PIN reset OK!" will open. Click on "OK" to close the window. The amplifier
can now be unlocked using PIN 1234.
4