Introduction; Installation And Connection - LD Systems CURV 500 iAMP Manuel D'utilisation

Masquer les pouces Voir aussi pour CURV 500 iAMP:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17

INTRODUCTION

The LD CURV 500 IAMP software is used to update the device firmware, load current loudspeaker presets, to manage individual global presets
in 16 memory locations and to reset the PIN to factory setting if necessary. The software is compatible with Windows operating systems 7, 8
and 10 and requires a USB interface (version 2.0) for data connection.

INSTALLATION AND CONNECTION

Download the software package from the product page at WWW.LD-SYSTEMS.COM, unzip the file and first of all install the USB driver
CDM 2_xx_xx on your Windows PC. Connect the USB port of the CURV 500 IAMP to the USB port of your computer using a suitable USB
cable (USB 2.0, USB-A to USB-B) and switch on the CURV 500 IAMP (driver installation may take a few moments). Start the Device Manager
on your computer and check the COM port number of the "Prolific USB-to-serial comm port" under "Ports (COM & LPT)" (in the example,
COM6). Now start the software "LD SYSTEMS DSP UPDATER" (double-click on the software icon). Ensure that baud is set at 57600. If
necessary, select the com port number previously checked in Device Manager under "COM Port" and click on "Connect". The display field
"Status" will change colour to green and you can check correct connection by clicking on the "Test USB" button (USB connection OK). To
terminate the connection, click on "Disconnect".
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ldcurv500iamp

Table des Matières