Filling The Water Tank - DS Produkte WJ 528 Mode D'emploi

EN
Attaching / Detaching the Combi-Attachment / Brushes / Crevice Attachment
3. To detach, simply pull the combi-attachment, the crevice attachment or a brush off
the adapter.
4. Press the release button (A) and pull the adapter out of the handle or extension tube.
Attaching / Detaching the Microfi bre Cloth
B
C

Filling the Water Tank

PLEASE NOTE!
■ Never pour any cleaning agent or additives into the water tank. This may destroy
the device and safe working is no longer guaranteed. Use distilled water or cold tap
water to fi ll it.
■ Do not overfi ll the water tank, pour in no more than 1.5 l.
We recommend that you pour cold distilled water into the water tank (4) in order
to prevent calcifi cation, particularly if the tap water is very hard.
1. To attach it, fi rst plug the adapter for attachments either di-
rectly onto the handle (1) or attach extension tubes before-
hand (see the "Attaching / Removing Extension Tubes"
section).
2. Plug the combi-attachment, the crevice attachment or one
of the brushes onto the adapter.
PLEASE NOTE: When plugging on the combi-attach-
ment, make sure that the arrows on the adapter and the
attachment are pointing towards one another.
• For use with the microfi bre cloth, remove the scraper lip
from the combi-attachment: To do this, pull the locking
catch (B) backwards, fl ip the scraper lip (C) down and un-
hook.
• Attaching: Pull the microfi bre cloth over the combi-attach-
ment.
• Detaching: Pull the microfi bre cloth off the combi-attach-
ment.
1. Unscrew the water tank cap (3).
2. Use the measuring cup to pour cold, clean water into the water
tank (max. 1.5 l).
3. Screw on the water tank cap again so it is hand-tight.
24