Air System; Fuel - RAIS/attika VISIO 3-1 NS Manuel D'utilisateur

English

Air system

Mounting the Air-system ensures that the air control system receives fresh air from
outside.
To ensure that the Air- system work you have to build it, in such a way, to ensure that
there cannot develop low pressure in the home.
If convection grilles are installed, they must not be blocked.
Air connection (optional) can be installed underneath the stove.

Fuel

The stove has been tested in accordance with DS/EN 13229: 2001, DS/EN 13229: 2001/
A1: 2003 DS/EN 13229: 2001/A2: 2004 and NS 3058/3059 for the stoking of split dry
birch and approved for hardwood/softwood. The firewood must have a water content
of 15-20 % and its maximum length should not exceed 30 cm.
Stoking with wet firewood causes both soot, environmental pollution and bad fuel
economy. Freshly cut wood contains approx. 60-70% water, and is completely unsuit-
able for stoking.
You should allow for, that newly cut wood must be stacked for drying for 2 years.
Wood with a diameter of more than 100 mm should be split. Regardless of the size of
the wood, it should always have at least one surface area without bark.
It is not allowed to burn lacquered, laminated or impregnated wood, wood
with a synthetic surface, painted refuse wood, chipboard, plywood, domestic
waste, paper briquettes and pit coal, because it knows malodorous fumes that
can be poisonous.
The burning of the above and of amounts larger than those recommended, the stove
is subjected to a larger amount of heat, resulting in a higher chimney temperature and
lower efficiency. This can result in the stove and chimney becoming damaged and the
warranty becoming void.
attika
RAIS/ - User manual for VISIO 3-1
150 mm flexible
hose (metal)
23 23