Convection - RAIS/attika VISIO 3-1 NS Manuel D'utilisateur

English

Convection

There is a minimum requirement for the convection
observed due to danger of overheating and due to distance to flammable
materials. Make sure that the stove can pull convection air in under the stove.
And lead it back out of the stove.
When installed in a completely non-flammable construction, there are no
requirements for convection area but it is recommended to transfer the area
from the panel construction as the brick work may crack at high tempera-
tures.
22 22
attika
RAIS/ - User manual for VISIO 3-1
area. This area must be
Convection area above the stove on
instillation
must be minimum
the area can be distributed over
several holes.
Convection area below the stove on
instillation
Must be minimum
the area can be distributed over
several holes.
700cm²
530cm²