Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
SNAP-ON FITTING
• The hood can be installed either directly on the bottom
surface of the wall units using snap-on side supports.
(min. 650 mm above the hob).
• Cut a fitted opening in the bottom surface of the wall
unit, as shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws Vf from un-
derneath the hood.
SNAP-ON FITTING AND SCREWS FITTING
• The hood can be installed either directly on the bottom
surface of the wall units using snap-on side supports.
(min. 650 mm above the hob).
• Cut a fitted opening in the bottom surface of the wall
unit, as shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws Vf from un-
derneath the hood.
• Fix using the 10 or 8 screws 12a provided.
EN
259
13
Vf
259
13
12a
2 23
Publicité
Table des Matières
