Select Temperature - Whirlpool WTW4850XQ3 Guide D'utilisation Et D'entretien

7.

Select Temperature

Once you select a cycle, select the desired wash temperature
by turning the Temperature knob to the appropriate setting
based on your load. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Wash Temp
Hot
Some cold water is added to save
energy. This will be cooler than
your hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Cool Lights
Warm water is added to assist in
soil removal and to help dissolve
detergents.
Cool Darks
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Cold
This is the temperature from your
faucet. If your tap cold water is
very cold, warm water may be
added to assist in soil removal and
help dissolve detergent.
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Dark colors that bleed
or fade
Light soils
Dark colors that
bleed or fade
Light soils
8.
Select options
Select the desired cycle options. If you are using fabric
softener, be sure to select Fabric Softener Added-Yes option.
9.
Press START/Pause/Unlock
to begin wash cycle
Press the START/Pause/Unlock button to start the wash
cycle. Filling is delayed for several minutes while load
balance is sensed. When the cycle has finished, the DONE
indicator will light. Promptly remove garments after cycle
has completed to avoid odor, reduce wrinkling, and rusting
of metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock; the lid will unlock once the
washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close
lid and press START/Pause/Unlock again to restart the cycle.
If lid is left open for more than 10 minutes, the water will
pump out automatically.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to filling.
This is normal operation.
9