Changing/Replacing Belts; Removing Guides - Work Sharp E5 Mode D'emploi

CHANGING/REPLACING BELTS

1. Pull open the front cover of the unit. Cover is
secured with magnet.
2. Press down on the tensioner, located behind the
top, large pulley (wheel).
3. Holding tensioner down, slide belt off.
4. Lift up tensioner to find extra belt storage.
5. To install new belt, hold tensioner down and slide
belt around all 3 pulleys (wheels).
For more info about belts, see SHARPENING
BELT INFORMATION section.

REMOVING GUIDES

1. Push back on guide from the front of the
sharpener until the guide snaps out of place.
2. Lift the guide to remove.
Remove guides to clean debris on the
T I P 1:
leather liner with a dry cloth or brush.
Remove right or left guide to access
T I P 2:
scissor guide. See SCISSOR/SHEARS section
for more detail.
3. To reinstall guide, align screw with hole on
sharpener.
4. Push the guide forward toward the front of the
sharpener until it snaps into place. Make sure it is
flush with the sharpener.
The E5 Upgrade Kit includes expandable sharpening capabilities with 15°
EAST GUIDES and 20° WEST GUIDES (sold separately).
With the belt removed, lift the belt tensioner to
reveal belt storage space.
Belt Tensioner
Belts
OFF
ON
7