Installation Instructions; Unpacking; Product Description; For All Appliances - Bosch TR4000 Notice De Montage Et D'utilisation

CAUTION:
Earthed water pipes may give the appearance of a connected
protective earth.
• The continuous-flow heater is suitable for connection to
DVGW-tested plastic pipes.
• After installation, electrically live parts must be touch
protected.
• The appliance should be disconnected from the electrical
mains supply when working on the water supply. After
service work is complete, proceed as during the first-time
appli-ance start-up.
• No changes may be made to the appliance.
• This appliance can be used by children aged 8 years and
older as well as by persons with diminished bodily, sensory
or mental perception, or those who lack knowledge or
experience, if they are monitored or have received
instruction concerning use and comprehend the possible
dangers that can result. Children may not play with the
appliance. Cleaning and maintenance by the user may not
be performed by unsupervised children.
• Keep children away from the appliance.
• Please monitor children to ensure that they do not play with
the appliance.
• The warm water pipe may be hot. Please inform and
instruct children appropriately.
• If the power cord of this unit is damaged, it must be
replaced by the manufacturer, an authorised servicing
agent or a similarly qualified person so as to avoid danger.
• Do not use aggressive or abrasive cleaning detergents!
• Do not use a steam cleaner.
• The appliance is only to be descaled by a suitably qualified
specialist.
Please read this installation and operating instruction
manual carefully, then act accordingly! Store for future
reference.
2

Installation instructions

Install the continuous-flow heater as described in the
illustrated section. Observe the instructions in the text.
The illustrations can be found in the centre of the instruction
manual.
2.1

Unpacking

• Inspect the new appliance for transport damage!
• Please dispose of the packaging, and if applicable,
the old appliance in an environmentally-friendly manner.
TR4000 | TR4000R – 6 720 876 021 (2017/11)
Scope of delivery (Fig. 1)
1. Housing
2. Mounting (3 screws, 3 wall plugs)
3. Operation indicator
(only on TR4000 6 EB and TR4000 8 EB)
4. Installation bracket
5. Mounting bracket
6. Aerator
7. Documentation
2.2

Product description

The electronic continuous-flow heater is suitable for both open
(unpressurised) and closed (pressurised) connections. It heats
the water as it passes through the appliance.
The continuous-flow heater switches on and heats the water
when the warm water tap is opened. It switches off as soon
as the tap is closed.
The appliance may not be operated with pre-heated water,
as otherwise the overtemperature protection will trip.
This installation and operating instruction manual describes
various appliance types:
Over-sink appliances:
• TR4000 6 EB and TR4000 8 EB:
for fixed electrical connection
Undersink appliances:
• TR4000 4 ET and TR4000R 4 ET: with plug connection
• TR4000 5 ET, TR4000 6 ET and TR4000 8 ET:
for fixed electrical connection
Only for permanently installed appliances:
The device is compliant to IEC 61000-3-12.
Preparations for installation (Fig. 2)
• Shut off the water supply before connecting the
appliance. The electrical connection must be
disconnected from the mains supply. Unscrew the fuse
or switch off the circuit breaker.
2.3

For all appliances

A clearance of about 60 mm on all sides of the appliance
is required for installation.
• Observe the technical appliance data.
• Break out the installation bracket from the rear of the
appliance (A).
2.4

Only for TR4000 4 ET and TR4000R 4 ET

• Break out one of the side knock-outs (B1) provided for an
incoming electrical supply cable.
• Feed the desired length of the incoming electrical supply
cable downwards through the knock-out (B2).
Installation instructions
11