Lower Blade Guard - DeWalt DW367 Guide D'utilisation

FIG. 2
I
the blade wrench (screw has right-hand threads and must be
turned counterclockwise to loosen).
2. Remove the blade clamping screw (E) and outer clamp washer
(H) only. Remove old blade.
3. Clean any sawdust that may have accumulated
in the guard or clamp washer area and check
the condition and operation of the lower blade
guard as previously outlined. Do not lubricate
this area.
4. Select the proper blade for the application
(see Blades). Always use blades that are the
correct size (diameter) with the proper size
and shape center hole for mounting on the
saw spindle. Always assure that the maximum
recommended speed (rpm) on the saw blade
meets or exceeds the speed (rpm) of the saw.
FIG. 3
FIG. 4
J
7
5. Follow steps 2 through 6 under To Install the Blade, making
sure that the blade will rotate in the proper direction.

LOWER BLADE GUARD

WARNING: The lower blade guard is a safety feature which
reduces the risk of serious personal injury. Never use the saw if
the lower guard is missing, damaged, misassembled or not
working properly. Do not rely on the lower blade guard to protect
you under all circumstances. Your safety depends on following
all warnings and precautions as well as proper operation of the
saw. Check lower guard for proper closing before each use as
outlined in Additional Safety Rules for Circular Saws. If the
lower blade guard is missing or not working properly, have the
saw serviced before using. To assure product safety and
reliability, repair, maintenance and adjustment should be
performed by an authorized service center or other qualified
service organization, always using identical replacement
parts.
K
DW367, DW368
DW369
LOOSEN
J
TIGHTEN