DeWalt DW367 Guide D'utilisation page 10

Cutting Depth Adjustment (Fig. 5, 6)
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories.
1. Hold the saw firmly. Raise the depth adjustment lever (J) to
loosen and move shoe to obtain the desired depth of cut,
as shown. Make sure the depth adjustment lever has been
retightened (lowered) before operating the saw.
2. Your saw is equipped with a carbide tipped saw blade for long life
and efficient cutting.
3. Setting the saw at the proper cutting depth keeps blade friction
to a minimum, removes sawdust from between the blade teeth,
results in cooler, faster sawing and reduces the chance of
kickback. Align the appropriate mark on the depth adjustment
strap with triangle on the upper blade guard (K). Your depth is
set.
FIG. 6
FIG. 5
4. For the most efficient cutting action using a carbide tipped saw
blade, set the depth adjustment so that about one half of a tooth
projects below the surface of the wood to be cut.
5. A method of checking for the correct cutting depth is shown in
Figure 6. Lay a piece of the material you plan to cut along the
side of the blade, as shown in the figure, and observe how much
tooth projects beyond the material.
Bevel Angle Adjustment (Fig. 7, 8)
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories.
The full range of bevel adjustment on the DW367 is 0 to 50 degrees.
The pivot bracket is graduated in 5 degree increments.
On the DW368 and DW369, the full range of bevel adjustment is
0 to 56 degrees. The pivot bracket is graduated in increments of
1 degree.
There is a bevel angle adjustment mechanism (M) consisting of a
quadrant with a pointer (N) and a lever (L) on the front of the saw.
FIG. 7
M
N
8
LOOSEN
TIGHTEN
L