Heating With Brown Coal Briquettes; Banking The Fire And Raising The Temperature; Emptying The Ash Drawer - HASE Bari Mode D'emploi

9.

Heating with Brown Coal Briquettes

Wood should be used for the warming-up phase and when
adding fuel for the fi rst time, see "Warming-up Phase". As
soon as a basic glowing fi rebed is reached, place 2-3 brown
coal briquettes on the grate in the middle of the fi rebox, kee-
ping a fi nger's width between the briquettes, and use the
following procedure and settings:
Heating with Brown Coal Briquettes
Procedure
Open primary air completely. Slide primary air slider all
the way to the middle.
Adjust secondary air completely. Set secondary air slider
(II) to position 2.
Open fi re grate. Pull out fi re grate slider.
Tab. 3
36

10. Banking the Fire and Raising the Temperature

Keep the stove set as described above until the brown coal
briquettes are thoroughly burnt. Then close the primary air (I)
and the fi re grate. Slide the secondary air slider (II) to position
2/3.
NOTE!
While the stove is in operation, the secondary
air slider should never be completely closed.
Position of
To raise the temperature of the fi re, stir up the rest of the
Control Elements
glowing embers with the fi re grate slider. Open the primary air
(I) and add new logs to the fi re.

11. Emptying the Ash Drawer

As a safety precaution, please make sure to wait until the
ashes are cold before you dispose of them. While the ash
collects during the fi re, the lid is located under the ash drawer.
Remove both the ash drawer and the lid located underneath
it. Slide the lid onto the ash drawer so that it is closed; this
prevents ashes from fl ying around, which in turn means your
home stays clean. To place the ash drawer back into the stove,
proceed in the reverse order.
CAUTION!
Piled up ashes can impair or even block the
supply of primary air supply to the stove.
Please ensure that the air supply path for the
primary air between the ash drawer and the
bottom of the ash compartment remains clear.