Table des Matières
Publicité
3. Check hydraulic oil level once a month (Fig.54).
Fig.54
NOTE:
BEFORE
CHECKING,
ALL
COMPLETELY RETRACTED.
If necessary add:
ESSO
:
Nuto H 46
SHELL
:
Tellus oil 46
TOTAL
:
Azolla 46
Oil change is not required.
4. Clean and grease once a month the sliding bar
of the toolholder arm (Fig.55).
Fig.55
5. Clean the jaws of the chuck with a wire brush
once a month.
HOFMANN behält sich das Recht zu Änderungen ohne Vorankündigung vor _ HOFMANN reserves the right of modification without notice _ Document non contractuel
monty 4400
Betriebsanleitung Operator's Manual Notice d' utilisation
599
CYLINDERS
MUST
BE
440
Modéle : monty 4400_D _GB _F - Release D
7.0 MOVING THE MACHINE
In case the machine is to be moved from a work-
ing place to another, proceed as follows:
Disconnect the machine from the electric supply.
Before lifting the machine, ensure that the chuck is
completely closed, the chuck arm lowered, and
that the arm beam support and carriage beam
support are in the position indicated in Fig. 56.
Use belts of a length of mm 3000 (10') and capaci-
ty of kg 1000 (2200 lbs).
Hold the machine as depicted in Fig.56.
Fig.56
8.0 PUTTING THE MACHINE OUT OF SERVICE
If the machine is to be idle for a long period of time
(6 months or more) it is necessary to close the
chuck arm, retract all hydraulic cylinders and dis-
connect all power sources. Protect all parts that
may be damaged, protect the hydraulic hoses
that may be damaged because of a drying pro-
cess.
When putting the machine back in operation, first
check the condition of all previously protected
parts, and check for correct functioning of all de-
vices before using the machine again.
9.0 SCRAPPING THE MACHINE
Once it is decided to discontinue use of the ma-
chine, it must be rendered inoperable by cutting
the electric cord.
Considered the machine as special waste, disman-
tle the machine into homogeneous parts (metal,
plastic, oils etc) and dispose of according to local
regulations.
49
397
Publicité
Table des Matières
