Table des Matières
Publicité
b
a
1
2
82
ii-2
3
ii-3
Installation Instructions
Unpacking instructions
Uncrate the machine paying particular attention when
cutting the plastic straps or during any other operation
which may be hazardous.
After removing the carton check for any visible damage
to the machine and its components.
In case of doubt call qualified personnel for assistance.
The packing materials (plastic bags, polystyrene, nails,
screws, wood etc.) must be properly disposed of. Place
the above mentioned materials into a trash container
and dispose per local regulations.
•
Remove the lifting racket (a, Fig.ii-3) and the
eyebolt (3, Fig.ii-3).
ALWAYS WEAR GLOVES WHEN UNCRATING THE
MACHINE TO PREVENT SCRATCHES OR
ABRASIONS DUE TO CONTACT WITH PACKING
MATERIALS.
Handling the machine
In case the machine is to be moved from one working
place to another, proceed as follows:
•
Fix the lifting bracket "a" to the wheel holder
flange after first removing the plastic cover; then position
it as shown in figure ii3.
•
Screw
the eyebolt (3, Fig.ii-3) securely in
the seating, in the area shown here and indicated by
the relative plate (Fig.ii-2).
•
Bring the tool holder arm "b" to its working
position and tie it to the wheel holder flange so it does
not move during transport.
•
Disconnect the electrical and pneumatic
power supplies.
•
Remove from the machine any accessories
or parts that might fall during handing and so cause
danger.
•
Fix the belts to the provided lift points (1, 2,
3, Fig.ii-3).
WARNING:USE LOAD STRAPS AND HOOKS WITH
A LOAD-BEARING CAPACITY OF AT LEAST 1000 KG.
•
Lift with a suitable hoist or fork-lift truck.
WARNING:
DO NOT USE METAL CABLES DO NOT USE
STORAGE BELTS
STRAPS.
Operator's Manual
DO NOT USE PACKING
monty universal 2
Publicité
Table des Matières
