Makita LS0815F Manuel D'instruction page 10

1
014274
To turn on the light, press the upper position (ON) of the
switch. To turn off the light, press the lower position
(OFF) of the switch.
CAUTION:
Do not look in the light or see the source of light
•
directly.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
•
may to lower the luminance.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and unplugged before working on the tool.
Failure to switch off and unplug the tool may result
in serious personal injury.
Storage of socket wrench with hex wrench on
its other end
014282
The socket wrench is stored as shown in the figure.
When the socket wrench is needed it can be pulled out
of the wrench holder. After using the socket wrench it
can be stored by returning it to the wrench holder.
Installing or removing saw blade
WARNING:
Always be sure that the tool is switched off
•
and unplugged before installing or removing
the blade. Accidental start up of the tool may
result in serious personal injury.
1. Switch for light
1. Socket wrench
with hex wrench
2
on its other end
2. Wrench holder
1
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to use the
wrench may result in overtightening or insufficient
tightening of the hex bolt and serious personal
injury.
014303
Lock the handle in the raised position by pushing in the
stopper pin.
1
010390
To remove the blade, use the socket wrench to loosen the
hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center cover.
1
2
010391
Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
NOTE:
If the inner flange is removed be sure to install it
•
on the spindle with its protrusion facing away from
the blade. If the flange is installed incorrectly the
flange will rub against the machine.
WARNING:
Before mounting the blade onto the spindle,
•
always be sure that the correct ring for the
blade's arbor hole you intend to use is
installed between the inner and the outer
10
1. Stopper pin
1
2
1. Socket wrench
2. Blade case
3. Center cover
3
4. Hex bolt
5. Blade guard
5
4
1. Blade case
2. Socket wrench
3. Hex bolt
4. Arrow
5. Shaft lock
5
4
3