Basic Functions; Zeroing, Data Recvovery; Abs/Inc Mode; Coordinate Inputting - HOLZMANN MASCHINEN ED400FD Manuel D'utilisation

25.3

Basic Functions

25.3.1 Zeroing, Data Recvovery

c) Zeroing the displayed value of a coordinate
Press , to reset the display value of the X axis to zero.
Press , to reset the display value of the Y axis to zero.
Press , to reset the display value of the Z axis to zero.
d) Recovering accidentally zeroed data
Press , to reset the display value of the X axis to zero.
Press , to reset the display value of the Y axis to zero.
Press , to reset the display value of the Z axis to zero.

25.3.2 ABS/INC Mode

The position indicator provides two sets of standard coordinate display values, namely ABS
(absolute) and INC (relative) coordinates.
The operator could store the reference zero point of the workpiece at ABS coordinate, and
convert the ABS coordinate to the INC coordinate for machining.
Zeroing at any position on INC coordinate won't affect the length value relative to the reference
zero point of the workpiece at ABS coordinate, which shall be stored during the entire machining
process and could be checked whenever necessary.
Press or , to change from one mode to another.

25.3.3 Coordinate Inputting

This operation allows the operator to set the current position to any value.
In ABS mode press
Set the desired value by pressing
Press or to switch to the previous/next digit.
After setting the desired values , press to exit the menu.
In ABS mode press
In ABS mode press

25.3.4 1/2 function

The DRO provides an automatic centring function which divides the currently displayed position
by 2 and sets the zero point at the centre of the workpiece.
To call the function, first press
half.
For example, to halve the value of the X-axis, press
To half the value of the Y-axis, press
To half the value of the Z-axis, press
HOLZMANN MASCHINEN GmbH
DIGITAL POSITION INDICATOR (DITRON DL50 SERIES)
until the figures start flashing to start entering coordinates for the X axis.
and
until the figures start flashing to start entering coordinates for the Y axis.
until the figures start flashing to start entering coordinates for the Z axis.
and than the key of the coordinate whose value you want to
and than
and than
www.holzmann-maschinen.at
.
.
an than press
.
.
62
ED400FD | ED400FDDIG