Visual Inspection - HOLZMANN MASCHINEN ED400FD Manuel D'utilisation

Carefully disassemble the jaw chuck. To do this, loosen the cam-locks by turning
them clockwise (approx. one third of a turn) using the clamping key supplied and
carefully remove the jaw chuck.
Check the cam-lock studs. Ensure that they are not damaged or broken during
transport. Clean all parts thoroughly. Also clean the spindle and the cam-locks.
Lightly oil the spindle, cam-locks, camlock studs and chuck body with a suitable
machine oil.
Then lift the jaw chuck up to the spindle nose and press on the spindle. Tighten the
cam-lock studs by turning the cam-locks counterclockwise. After tightening, the
cam-lock line should be located between the two V-marks - see illustration on the
left.
If a cam is not within this mark, remove the chuck or face plate and adjust the
height of the cam-lock studs - see the following illustration.
The cam-lock stud is correctly adjusted when the mark (C) carved into the stud is
flush with the back of the chuck.
If the cam-lock line is outside the V markings, adjust the height of the relevant
cam-lock stud.To do this, first loosen the retaining screw (B), adjust the cam-lock
stud by turning it in/out one full turn at a time and then tighten the retaining
screw firmly again.
If the chuck (clamping device) is correctly fastened, a reference mark should be
attached to the spindle and clamping device so that the clamping device can
always be released and remounted in the same position to ensure optimum
concentricity.
Do not change chucks or face plates between lathes without checking for correct
cam-locking.

18.1.7 Visual Inspection

The machine is delivered without lubricant! These must be filled or applied before the
lathe is put into operation. Non-observance can lead to serious damage to the
machine. For running operation, use a viscous oil with viscosity ISO 220 (e.g. GOE5L)
or a comparable SAE140 oil or a multi-purpose grease of class 2NLGI for lubrication.
The lubrication points bed slideway, dovetail guide cross slide, dovetail guide longitudinal slide
and tailstock spindle sleeve are lubricated with the aid of an oil can and a commercially available
oil can while moving the slide or the quill back and forth.
Lubricating Points:
A: lathe slide B: cross slide
HOLZMANN MASCHINEN GmbH
NOTICE
NOTICE
Lubricants are toxic and must not be released into the environment!
Follow the manufacturer's instructions and contact your local authority if
necessary for information on proper disposal.
C: gear
www.holzmann-maschinen.at
D: lead screw
ED400FD | ED400FDDIG
ASSEMBLY
49