Dexter power AC 06 Traduction Du Manuel D'origine page 25

Trouble-shooting
Failure Possible cause
Motor does not Fault in electric current or mains
start, runs too voltage too low.
slowly, or gets
Electric cable too long or too thin.
extremely hot.
Faulty pressure switch.
Faulty motor.
Vibrations or Loose parts.
strange noise.
Foreign body in compressor.
Insufficient Motor runs too slowly.
pressure or drop in
output capacity.
Dirty filter cartridge.
Leakage in safety valve.
Leakage in tube.
Gasket damaged.
Valve seat damaged or covered with
carbon layer.
• D a t a o f m o t o r r a t i n g l a b e l
Remedy
Check mains voltage.
Get a new cable from your dealer.
Have it repaired or replaced by your dealer.
Have it repaired or replaced by your dealer.
Have checked by your dealer and repaired, if
needed.
Have checked by your dealer and repaired, if
needed.
Have checked by your dealer and repaired, if
needed.
Clean or replace filter cartridge.
Have switch repaired or replaced by your dealer.
Have checked by your dealer and repaired, if
needed.
Have checked by your dealer and repaired, if
needed.
Have checked by your dealer and repaired, if
needed.