Cleaning And Storage; Troubleshooting - DS Produkte SLG5003-18 Mode D'emploi

4. Move the temperature control to the MAX position to preheat the device. The preheating
process lasts about 5 minutes. The device has reached operating temperature when
the heating control lamp lights up. Please note that during the grilling process the
heating control lamp may go out and then light up again at regular intervals as the
device reheats and then stops heating in order to maintain a constant temperature.
5. Now use the temperature control to set the device to the temperature setting you want.
6. Open the device by opening up the device by the handle.
If you want to use the device as an open table-top grill, pull the locking catch
forwards and fully open up the upper part of the housing at the same time.
7. Place the food that you want to prepare on the lower grill plate and close the device.
8. Keep the device closed for a few minutes. Remove your food when it is as cooked
and brown as you want it to be.
9. Use only a wooden or plastic utensil to remove your food.
10. Disconnect the device from the mains power after use and allow it to cool down
before you clean it.

Cleaning and Storage

CAUTION!
• Remove the plug from the mains socket before doing any cleaning.
• Do not immerse the device in water or other liquids to clean it.
• Do not put the device in the dishwasher to clean it.
• Always allow the device to cool down before cleaning it.
• Do not use any corrosive or abrasive cleaning agents to clean the device. These can
damage the surface.
• Make sure the device is switched off!
• Clean the device and grill plates with a soft kitchen towel and a little mild detergent.
Then dry the device well.
• Clean the fat collecting tray using hot water and mild detergent. Then thoroughly dry
the tray.
• Store the device and the fat collecting tray in a dry, protected place.

Troubleshooting

If the device is not working properly, please check fi rst of all whether you are able to
rectify a problem yourself.
Do not attempt to repair a defective device yourself!
Problem
The device does not work
/ the operating lamp does
not light up.
17
Possible cause / solution
• Is the mains plug correctly inserted in the plug socket?
• Is the plug socket defective? Try another plug socket.
• Check the fuse of your mains connection.
EN