Use - DS Produkte SLG5003-18 Mode D'emploi

EN
• Do not use any caustic or abrasive cleaning agents for cleaning. These may damage
the device.
1. Unpack all parts and check the items supplied for completeness (see the "Items
Supplied and Device Overview" chapter) and transport damage. Remove all fi lms
and stickers that may be present. If the device does have any damage, do not use
it(!), but contact our customer service department.
2. Clean the device and grill plates with a soft kitchen towel and a little mild detergent.
Then dry the device well.
3. Place the device on a dry, heat-resistant, fl at surface with suffi cient clearance on all
sides and above (around 30 cm).
4. Insert the mains plug into a properly installed 230 V plug socket. Make sure that the
cable is not trapped between the grill surfaces! Move the temperature control
to the highest setting and allow the device to heat up for around 5 - 10 minutes to
remove any possible production residues.
5. Switch the device off by pulling the mains plug from the mains socket.
6. Allow the device to cool down and then clean it again with a soft kitchen towel and a
little mild detergent. Then dry the device well.

Use

CAUTION!
• Caution: Danger of burns! The device will become hot during use. Make absolutely
sure that you do not come into contact with any heated parts such as the housing
or the grill plate during and after use of the device. Only touch the device by the
handles provided and use oven cloths or kitchen gloves when handling the device.
Only clean, transport and store away the device after it has cooled down completely.
• If you have burnt yourself on a hot surface, cool the spot immediately with cold water
and consult a doctor immediately to get treatment for the burn.
• When opening the device, keep a suffi cient distance to prevent burns caused by
heat or hot steam.
• The device should only be used and stored out of the reach of children. The mains
cable must also be kept out of the reach of children.
• Never use the device without the fat collecting tray. Cooking fat runs out of the fat
drain on the back of the device when it is used! Always insert the fat collecting tray
into the device before it is used!
The device is suitable for grilling and frying fi sh, meat and vegetables and for
preparing toasted sandwiches etc.
1. Place the closed grill on a stable, even, heat-resistant surface.
2. Insert the fat collecting tray into the bottom of the housing.
3. Connect the device to a properly installed plug socket. The operating lamp lights up
as soon as the device is connected to the mains power. Make sure that the cable
does not come into contact with hot surfaces during use.
16