Correct Set-Up And Connection; Proper Use - DS Produkte SLG5003-18 Mode D'emploi

• When the device is fi rst used, light smoke and smells may de-
velop. This is nothing unusual and does not impair the safety of
the device.

Correct Set-Up and Connection

• Use the device only in closed rooms.
• Always set up the device with enough clearance on all sides
and above (around 30 cm) and on a dry, even, stable and heat-
resistant surface.
• Maintain suffi cient clearance from other sources of heat such as
hotplates or stoves in order to avoid damage to the device.
• In order to avoid electric shocks, do not use the device near wa-
ter or other liquids.
• The device should never be set up or used in the vicinity of high-
ly fl ammable materials (curtains, textiles etc.).
• Never operate the device on a hob or in the vicinity of a gas
source.
• The device should only be connected to a properly installed plug
socket with safety contacts. The plug socket must also be read-
ily accessible after connection. The mains voltage must match the
technical data for the device (see the "Technical Data" chapter).
Only use suitable extension cables whose technical data is the
same as that of the device.
• Make sure that the connected mains cable does not present a
trip hazard. Do not allow the cable to hang over the edge of ta-
bles or kitchen counters. Others may become caught and pull
the device down.
• Position the cable in such a way that it does not become squashed
or bent and does not come into contact with hot surfaces.
• Do not expose the device to extreme temperatures, strong tem-
perature fl uctuations, direct sunlight or moisture.

Proper Use

• Always check the device for damage before putting it into opera-
tion. If the device, the cable or the plug shows visible signs of
damage, the device must not be used. Do not use the device if it
has malfunctioned or been dropped.
13 EN