Safety Instructions For Maintenance - Husqvarna T535i XP Manuel D'utilisation

Pull out the plug to the battery charger if there is
smoke or fire.
• Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
• Only use the battery charger where the temperature
is between 5 °C (41 °F) and 40 °C (104 °F). Use the
charger in an environment which has a good airflow,
dry and free from dust.
• Do not put objects into the cooling slots of the
battery charger.
• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Use approved wall sockets that are not damaged.
• Use only three-wire outdoor extension cords that
have three-prong grounding plugs and grounding
receptacles that accept the appliance's plug.

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
Safety instructions for the cutting
equipment
WARNING: Read the warning instructions
that follow before you use the product.
• Use the correct combination of guide bar and saw
chain to decrease the risk of kickback! Only use the
bar/saw chain combinations we recommend and use
10
the correct filing equipment. See
page 27 for instructions.
• Use protective gloves when you handle the saw
chain. A saw chain that does not move can also
cause injuries to a person that touches the saw
chain.
• Keep the cutting teeth correctly sharpened! Follow
our instructions and use the recommended file
gauge. A damaged saw chain or a saw chain that
has been incorrectly sharpened increases the risk of
accidents.
• Keep the correct depth gauge setting! Follow our
instructions and use the recommended depth gauge
clearance. Too large a clearance increases the risk
of kickback.
• Make sure that the saw chain has the correct
tension! If the saw chain is not tight against the guide
bar, the risk for it to come loose increases. This
leads to increased wear on the guide bar, saw chain
and drive sprocket.
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. The risk of wear on
the guide bar, saw chain and drive sprocket
increases if the saw chain is not correctly lubricated.
Accessories on
959 - 001 - 16.11.2018