Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ON position, plug the jack plug
11
into the charging port
charger into any standard 120 Volt 60 Hz electrical outlet.
nOTE: The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
Using the 3 in 1 Accessory tool (Fig. J)
•
The 3-in-1 accessory tool
Brush mode.
-
-
Small crevice mode.
•
The 3-in-1 accessory tool
to the extension tube
shown in Fig. J.
•
Align the top of the 3-in-1 accessory tool
vacuum inlet
5
or extension tube
place so it locks into position as shown in Fig. J.
•
The flat nozzle can be used to clean the wall corner,
stairs, furniture crevices, and household appliance
cooling fins.
•
The combination of a flat nozzle with a brush can be
used to clean the furniture, curtains, lamps and lanterns.
Fig. J
10
Cleaning and emptying the vacuum
WARNING:
Never use the vac without its filter.
nOTE: The filter is re-usable, do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6–9 months depending on frequency of use.
There are two methods of cleaning the canister, a quick
empty method and a thorough clean method.
To empty the dust canister (Fig. K, L, M, O)
•
Pull back on the dust canister release button
release and remove the dust canister
vacuum
as shown in Fig. K.
15
•
Use your index finger and thumb to pinch the filter
housing tabs
17
and lift the filter housing
dust canister as shown in Fig. L.
nOTE: The filter housing fits snuggly in the dust canister
and may be difficult to remove at first.
•
Place the dust canister over a trash can and empty the
dust canister.
14
of the jack plug charger
4
of the vacuum. Plug the
10
has two configurations.
can be fitted either directly
10
or to the vacuum inlet
6
10
with the
6
and push into
Projectile/Respiratory Hazard:
16
from the
8
18
from the
•
Install the filter housing into the dust canister
ensuring the dust canister slots
housing tabs
•
Install the dust canister onto the vacuum, until it "clicks"
firmly into position.
nOTE: Ensure the dust port
main handle
release button
as shown in Fig O.
Fig. K
15
as
5
Fig. L
6
18
5
21
8
Fig. M
to
8
19
align with the filter
20
as shown in Fig. M.
21
is placed towards the
2
of the vacuum and the dust canister
16
is facing away from the vacuum
8
17
English
8
15
16
20
19
5
Publicité
Table des Matières
